Maretron FPM100 Manuel d'utilisateur télécharger pdf (Page 23)

Revision 1.3 Appendix A – NMEA 2000

Interfacing Page A1

®®

Appendix A – NMEA 2000

Interfacing

FPM100 NMEA 2000

Periodic Data Transmitted PGNs

PGN 130314 – Actual Pressure

The FPM100 uses this PGN to provide a regular transmission of various pressures. The

factory default for periodic transmission rate is once every two seconds. The transmission of

this PGN can be disabled (see PGN 126208 – NMEA Request Group Function – Transmission

Periodic Rate).

Field 1:SID – The sequence identifier field is used to tie related PGNs together. For example,

the FPM100 will transmit identical SIDs for 130312 (Temperature) and 130311

(Environmental Parameters) to indicate that the readings are linked together (i.e.,

the data from each PGN was taken at the same time although they are reported at

slightly different times).

2: Pressure Instance – The FPM100 sets this field to identify a particular pressure

measurement from the source specified in Field 3. Every pressure measurement

from a given source type on the network should have a distinct instance value, so

that monitoring devices and displays can identify which measurement is which.

3: Pressure Source – This field is used to indicate the type of pressure measurement

being taken. Possible values for this field include Atmospheric Pressure, Water

Pressure, Steam Pressure, Compressed Air Pressure, Hydraulic Pressure, and 16

User Defined pressure sources.

4: Pressure – This field is used to indicate the pressure, whose source is specified in

field 2, in units of 0.1 Pa.

6: Reserved bits – The FPM100 sets all bits in this field to a value of “1”.

PGN 127505 – Fluid Level

The FPM100 uses this PGN to indicate the attached tank’s fluid instance, fluid type, fluid level,

and tank capacity.

Field 1: Fluid Instance – This field is used to identify the tank number and ranges between 0

and 15. There can be up to 16 tanks of a given type as defined by the Fluid Type

field. This field is programmable through the NMEA command PGN. The FPM100

ships from the factory with a default value of zero.

2: Fluid Type – This field identifies the type of fluid contained within the tank. Currently

the defined fluid types are fuel, fresh water, wastewater, live well, oil, and black

water. This field is programmable through the NMEA command PGN. The FPM100

ships from the factory with a default value of 0x0 indicating “Fuel”.

3: Fluid Level – This field is used to indicate the current fluid level in percentage. The

value transmitted in this field depends on the distance from the sender to the top of

the fluid or tank bottom.

4: Tank Capacity – This field is used to indicate the tank capacity. This field is

programmable through the NMEA command PGN. The FPM100 ships from the

factory with a default value of 0xFFFFFFFF indicating “Data Not Available”.

5: Reserved – This field is reserved by NMEA; therefore, the FPM100 sets all bits to a

logic 1.

1 2 ... 18 19 20 21 22 23

Commentaires sur ces manuels

Pas de commentaire

Maretron FPM100 Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Moniteurs Maretron FPM100