Maretron Alarm Module ALM100 Manuel d'utilisateur télécharger pdf (Page 49)

100

101

top of the Dialog. Click on the line in the list and press the Use Selected as 1

Connection button.

This will populate the 1

Connection for a LAN connection as shown below. The

Serial Number will be entered into the line; if you entered a password in the

IPG100, enter the same password in the Password box.

f. If you are running on a PC or Mac and you have an IPG100 running on a different

Ethernet network as the PC or Mac, this cannot be detected by N2KView. You will

need to enter the IP Address of the gateway where established port forwarding to

the IPG100. Check the Use 1

Connection box, select WAN from the list of

methods and then enter the IP Address/Hostname and the Port of the global

port. This is the most difficult way to connect N2KView and the IPG100, and

should only be attempted by IT professionals

This will populate the 1

Connection for a LAN connection as shown below. The

Serial Number will be entered into the line; if you entered a password in the

IPG100, enter the same password in the Password box.

An example of this is shown below:

Revision 4.0.2 Page 49

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 379 380

Commentaires sur ces manuels

Pas de commentaire

Maretron Alarm Module ALM100 Manuel d'utilisateur Page 49

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Maretron Alarm Module ALM100